Applied-motion 7080i Manual de usuario

Applied Motion Products, Inc.404 Westridge Drive Watsonville, CA 95076Tel (831) 761-6555 (800) 525-1609 Fax (831) 761-65446/1/99Hardware Ma

-11--10-Limit SwitchesThe 7080i has two limit switch inputs, LIMIT CW and LIMIT CCW. By connecting switches or sensors that are triggered by the moti

Mechanical Outline - Optional MMI-2--19-4.90 4.90 1.380.133.875CENTERED3.875CENTERED123➝➝456➝➝789YES NO.0SPACE BKSP ENTER2.9881.9750.4250.9630.960GNDG

Technical Specifications-18-Block Diagram-3-Dual, MOSFET H-bridge, 3 state, pulse width modulated switching at 20 kHz. 0.8 - 7.0 amps/phase output cu

-17-I/O connectorcw limitccw limitcw jogccw joginputs 1 - 4outputs 1 - 3-4-LEDspowerover temp faultover current faultconnectormotorpower supplyRS232 c

Flush MountingWhen you remove the MMI from the shipping carton, you will notice that it has two parts. The first is a fairly thin section that contai

Mounting the Optional MMI There are two ways to mount the MMI in your application. No matter which method you choose, you'll need to connect the

-14--7-Connecting the MotorNever connect the motor to the driver when the power is on.Secure any unused motor leads.Never disconnect the motor while t

-13--8-A+A–B+ B–8leadmotor8 Leads Series Connected 8 Leads Parallel ConnectedA+A–B+B–8leadmotorOrangeOrg/WhtBlk/WhtBlackRedRed/WhtYel/WhtYellowOrangeO

-9--12-Wiring InputsEach input has a pull up resistor to the internal 5 volt power supply and an RC filter. Because of the pull up resistor, if nothi