Applied-motion SV7-IP-EE Manual de usuario descargar pdf (Pagina 2)

a) Select the “Motor - Encoder” tab and conrm settings for motor

maximum current and pole count, as well as the encoder resolution

are correct. If you are using a non-AMP motor, these data must be

obtained from your motor’s datasheet.

b) Execute the Timing Wizard, following the on-screen prompts. This will

ensure that the drive can properly commutate the motor.

Step 6

a) Select the “Tuning - Sampling” tab. If using an Applied Motion motor, click the “Open” button, navigate

to the SV7 folder, and select a tuning le. Select the le that most closely matches your inertia load.

The le names indicate the inertia ratio for which they were optimized. For example, the le V0200

48V 2.5X.svt was optimized for the V0200 motor at 48V and a 2.5:1 inertia ratio.

b) If using a third-party motor, the system must be tuned manually. Consult the Quick Tuner™ Software

Manual for step-by-step tuning instructions.

The Quick Tuner™ manual should be considered required reading for anyone tuning a servo system.

Step 7

Select the “Inputs - Outputs” tab, and congure any dedicated-function I/O your application

may require.

Step 8

Download your settings to the drive. Your drive is now congured for use.

Step 9

If you have any questions or comments, please call

Applied Motion Products Customer Support:

(800) 525-1609, or visit us online:

www.applied-motion.com.

404 Westridge Dr.

Watsonville, CA 95076

Tel: 800-525-1609

Fax: 831-761 -6544

www.applied-motion.com

920-0053 rev A

a) Apply power to the drive.

b) Enter the proper IP address (refer to step 1d above), then select the “Drive”

tab and press the “Ping” button. You should receive a response similar to

that shown here.

c) Select the appropriate operating mode for your drive.

d) If using an Applied Motion servomotor, press the “Open” button and select

a factory tuning le, paying close attention to the voltage and inertia ratio.

Step 5

1 2

Sin comentarios

Applied-motion SV7-IP-EE Manual de usuario Pagina 2