Applied-motion STM23C-3CE Manual de usuario descargar pdf (Pagina 8)

Geing Started

is manual describes the use of dierent drive models. What you need to know and what you must have depends

on the drive model. For all models, you’ll need the following:

• a 12 - 70 volt DC power supply. Please read the section entitled Choosing a Power Supply for help in

choosing the right power supply.

• a small at blade screwdriver for tightening the connectors (included).

• a personal computer running Microso Windows 98, 2000, NT, Me , XP, Vista or 7.

•

ST Congurator

™ and

Q Programmer

™ soware applications, available at hp://www.applied-motion.com/

products/soware.

• An Applied Motion programming cable (included in RS-232 Models, RS-485 converters are available from

AMP) or a CAT5 patch cable for Ethernet models.

If you’ve never used an STM23 drive before you’ll need to get familiar with the drive and the set up soware be-

fore you try to deploy the system in your application. We strongly recommend the following:

1. For Q/IP/C models, download and install the

ST Congurator

™ and

Q Programmer

™ soware applications,

available at www.applied-motion.com/products/soware. For S models, install the

ST Congurator

™.

2. Launch the soware by clicking Start...Programs...Applied Motion...

3. Connect the drive to your PC using the programming cable. When using RS-485, it must be set up in the

4-Wire conguration (See “Connecting to a host using RS-485” below). For Ethernet models, connect directly to

your PC’s Ethernet port or connect the STM23 to a router or switch. See page 20 for more information.

4. Connect the drive to the power supply.

5. Apply power to the drive.

6. e soware will recognize your drive, display the model and rmware version and be ready for action.

Mounting the Motor+Drive

As with any stepper motor the STM23 motors must be mounted so as to provide maximum heat-sinking and air-

ow. Keep space around the STM23 Motor+Drive to allow convected air-ow.

• Never use your drive in a space where there is no air ow or where other devices cause the sur-

rounding air to be more than 40°C.

• Never put the drive where it can get wet or where metal or other electrically conductive particles

can get on the circuitry.

• Always provide air-ow around the drive.

STM23 Hardware Manual

920-0021F

2/14/2012

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comentarios a estos manuales

Sin comentarios

Applied-motion STM23C-3CE Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Applied-motion STM23C-3CE