Applied-motion STR2 Manual de usuario descargar pdf (Pagina 7)

STR2 Hardware Manual

920-0059B

1/30/2014

Geing Started

To use your STR2 step motor drive, you’ll need the following:

• a 12 to 48 volt DC power supply. Please read the section

Choosing a Power Supply

for

help in choosing the right power supply.

• one of the motors listed recommended in this manual.

• a small at blade screwdriver for tightening the connectors.

• a source of step signals, such as a PLC or motion controller.

e connectors and other points of interest are illustrated below. ese are detailed later in

the manual.

Motor &

Power Supply

Connector

SWITCH A

Self Test

Step Noise Filter

Idle Current

Run Current

Steps/rev

Input & Output

Signals

SWITCH B

Motor Selection

Load Inertia

Status LEDs

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Sin comentarios

Applied-motion STR2 Manual de usuario Pagina 7