Applied-motion BLuAC5-Si Manual de usuario descargar pdf (Pagina 9)

BLuAC5-Si Hardware Manual

920-0035E

12/10/2014

Si Positioning: When creating or running an Si program this code commonly ap-

pears.

Serial Comm Error: Indicates a Serial Communication error. This error is also indi-

catedbytheCommTxandRxLEDsashinganalternatingpattern.

Positioning Mode: The drive is in Positioning Mode. This is the mode used when

performing point-to-point and other moves.

Velocity Mode: The drive is in Velocity Mode. This is the mode used with jogging or

with analog commanded velocity.

Torque Mode: The drive is in Torque Control Mode. This is the mode used for analog

commanded torque operation.

Step & Direction Mode: The drive is in Step and Direction Control Mode. This is the

mode used for encoder following or positioning using step and direction input.

Drive Disabled: The drive output is disabled.

Q Program Running: An outside segment will be rotating around the display. The

rotate rate is about 0.2 seconds per segment.

Drive Start-up test pattern: This pattern is displayed for a short period of time at

drive start-up.

Memory Fault: Q segment could not be executed because it was blank.

Serial Comm Timeout: A complete command packet was not recevied in the normal

amount of time. Applied to SCL and Q languages only, not used by Si Programmer.

Subroutine Stack Overﬂow: Too many subroutine calls have been made without a

return.

Subroutine Stack Underﬂow: A subroutine return instruction was executed before

any subroutine was called.

Seven Segment Display Status codes

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Sin comentarios

Applied-motion BLuAC5-Si Manual de usuario Pagina 9