Applied-motion ST10-C-CE Manual de usuario descargar pdf (Pagina 32)

ST5/10-Si,-Q,-C, -IP Hardware manual

920-0004 Rev. F

6/10/14

Wiring a Mechanical Limit Switch

You can use normally open or normally closed limit switches. Either way, wire them as shown

here. Be sure to set the polarity using the Si Programmer™ for Si™ drives or the ST Conﬁgurator™

software for the ST5-Q, ST10-Q, ST5-C and ST10-C.

Wiring a Limit Sensor

Some systems use active limit sensors that produce a voltage output rather than a switch or relay

closure. These devices must be wired differently than switches.

If your sensor has an open collector output or a sinking output, wire it like this:

If the sensor output goes low at the limit, select the option “closed” (in the software). If the output

is open, or high voltage, choose “open”.

Other sensors have sourcing outputs. That means that current can ow out of the sensor output,

but not into it. In that case, wire the sensor this way:

DRIVE

Power

Supply

–

Limit

Sensor

output

–

CW LIMIT+

CW LIMIT-

DRIVE

Power

Supply

–

Proximity

Sensor

output

–

CW LIMIT+

CW LIMIT-

DRIVE

12-24

VDC

SUPPLY

CW LIMIT+

CW LIMIT-

CCW LIMIT+

CCW LIMIT-

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Comentarios a estos manuales

Sin comentarios

Applied-motion ST10-C-CE Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Applied-motion ST10-C-CE